WASHER Parts in Yukon: Fast, Reliable Fixes for Your WASHER
What Is a Washer Drain Pump & How Does It Work?
The washing machine drain pump (also called drain pump motor assembly, wastewater pump, or pump & motor combo) is a small electric motor with an impeller that pushes dirty water from the tub through the drain hose and out to your plumbing during the drain and spin cycles.
- Front-Load Washers: Pump is at the bottom front, behind a small access panel.
- Top-Load Washers: Usually under the tub, accessed from the back or bottom.
When it fails, you get:
- OE (Outflow Error) – LG
- ND (No Drain) – Whirlpool
- LE / E1 – Samsung
- F21 / SUD – Maytag/Whirlpool
- Humming noise but no draining
- Water left in tub after cycle
- Slow spin or no spin
Oklahoma Reality: Coins, hair ties, socks, and hard water mineral buildup jam the impeller in 2–4 years. Clean the pump filter first—but if the motor won’t run, replace the drain pump.
Why Choose YAP for WASHER Parts in Yukon?
Quality Parts that Yukon Locals Can Trust.
Washer Parts Are a Phone Call Away in Yukon
- Genuine OEM Parts: Avoid cheap knockoffs with our high quality Whirlpool dryer parts, Samsung dryer parts, and more.
- Fast Local Service: Pickup at our Yukon office or drop ship for a small fee. No waiting weeks for shipping.
- Affordable Prices: Competitive rates on dryer repair kits like the popular 4392067 Whirlpool kit.
- Expert Guidance: Not sure what part you need? Enter your model number or call 405-876-8100 we'll match it perfectly.
- Yukon Tough: Parts built to handle our harsh winters and heavy use.
Searching for dryer parts near me or Yukon washer repair parts? Browse our selection or contact us today!
DIY WASHER DRAIN PUMP Repair Tips for Yukon Homes
Step-by-Step DIY: Replace Your Washer Drain Pump
Tools Needed: Phillips & flathead screwdrivers, pliers, shallow pan, towel
For LG Front-Load (TCA36411702)
- Unplug washer, turn off water.
- Open bottom front panel (clips or screws).
- Place pan under filter – twist open, drain water.
- Unplug pump wires (1 harness), squeeze hose clamps, remove 2 hoses.
- Unscrew 3 pump screws, twist out old pump.
- Install TCA36411702 – reverse steps.
- Run Rinse + Spin – no leaks? Done!
Time: 20–30 min
For Whirlpool / Kenmore (WPW10314173)
- Unplug, tilt washer back or remove back panel.
- Locate pump (bottom center).
- Disconnect wires & hoses (note positions).
- Twist or unscrew pump (3 tabs or screws).
- Install new WPW10314173, reconnect.
- Test drain cycle.
Time: 25–40 min
